Improve the bonding material properties used to strengthen concrete beams
Article Sidebar
This work is licensed under a Creative Commons Attribution 4.0 International License.
Main Article Content
Abstract
The subject of the research deals with the study of the effect of recycling and addition of some cheap and locally available materials on the properties of the adhesive material (Epoxy) used to strengthen concrete beams. Where the study included the addition of glass powder, brick powder and porcelain powder to the adhesive material and with different ratios of the weight of the adhesive material (0, 0.25, 0.5, 0.75, 1 and 1.25). After conducting laboratory tests proved the results of the study that the best types of additions are porcelain powder and the best ratio of adding was about ( 0.25). This addition to the adhesive material in this ratio led to improve the reaction temperature at mixing the parts of the adhesive material where decreased by 15.56%, as well as improved workability through lower flow of the consistency of adhesive material about 7.89%, as increased compressive strength by 13.33% and improved the modulus of elasticity by11% only, but The modulus of rupture decreased by 7.04% and the strength to high temperatures (limit to 250C°) decreased by 29.17%. The new bonding material was tested to strengthen the CFRP concrete beams. The results showed that the compressive strength of these beams increased by 70.97% compared to the normal non-reinforced beams and the strength of the Toughness beams increased by 61.87%.
© 2018 JASET, International Scholars and Researchers Association
Downloads
Metrics
Article Details
References
Ahmed S. Abdulaziz , Ahmed Nafie Rashid, Yasir M. Al Hbaite , 2013. Adhesive strength improvement of epoxy resin with different reinforcing materials . Al- Rafidain Engineering. Vol.20. No. 6 . DOI: https://doi.org/10.33899/rengj.2013.82403
Abdulla, A.I., Hashim Abdul Razak , Yassen Ali Salih , Muataz Ibrahim Ali, 2016. Mechanical properties of sand modified resins used for bonding CFRP to concrete substrates . International Journal of Sustainable Built Environment. 5, 517-525 . DOI: https://doi.org/10.1016/j.ijsbe.2016.06.001
Abdulla, A.I., 2016. Thermal properties of sand modified resins used for bonding CFRP to concrete substrates . Int. J. Sustainable Built Environ. 5 (1), 176-182. DOI: https://doi.org/10.1016/j.ijsbe.2016.03.001
Blanksvärd , Thomas, 2009. Strengthening of concrete structures by the use of mineral-based composites (Ph.D.) . Lulea University University of Technology, Sweden. DOI: https://doi.org/10.1061/(ASCE)1090-0268(2009)13:1(25)
Cabral-Fonseca, Susana, Nunes , João Pedro, Rodrigues , Maria Paula, Euse'bio , Maria Isabel, 2011. Durability of carbon fiber reinforced polymer laminates used to reinforced concrete structures . Sci. Eng. Compos. Mater. 18, 201-207. DOI: https://doi.org/10.1515/SECM.2011.041
Camata , Guido, Pasquini , Franco, Spacone , Enrico , 2007. High temperature flexural strengthening with externally bonded FRP reinforcement . In: Paper Presented at the Proceedings of 8th International symPosium on Fiber Reinforced Polymer (FRP) Reinforcement for Concrete Structures (FRP8RCS). Patras , Greece.
Gao , Bo, Kim, Jang.-Kyo , Leung, Christopher K.Y., 2004. Experimental study on RC beams with FRP strips bonded with rubber modified resins . Compos. Sci. Technol. 64 (16), 2557-2564. DOI: https://doi.org/10.1016/j.compscitech.2004.05.016
Kereem , H.A., 2002. Study the influence of adding nickel powder to a thermosetting epoxy resin on the mechanical Properties . M. Sc.Thesis, University of Technology, Baghdad.
Klamer , Ernst L., Hordijk , Dick A., Hermes, Michael C.J., 2008. The impact of temperature on RC beams strengthened with externally bonded CFRP reinforcement . Heron 53 (3), 157-185.
Mohammed Abdulsattar Mohammed, 2011 . Mechanical behavior for polymer matrix composite reinforced by copper powder . Nahrain University, College of Engineering Journal (NUCEJ) Vol.14, No.2, pp. 160-176. DOI: https://doi.org/10.22401/JNUS.14.1.22
Osman Asi , 2008. Mechanical Properties of glass-fiber reinforced epoxy composites filled with Al2 O3 particles . Journal of Reinforced Plastics and Composites . DOI: https://doi.org/10.1177/0731684408093975
Täljsten , Björn , Blanksvärd , Thomas, 2007. Mineral-based bonding of carbon FRP to strengthen concrete structures.J. Compos. Const. 11 (2), 120-128. DOI: https://doi.org/10.1061/(ASCE)1090-0268(2007)11:2(120)
Balqis Mohammed Deyaa, Hassan Shaker Majdi, Raghd Hussein Mohammed, 2009 . . A study effect ultraviolet radiations (UV) على on some mechanical properties for composites of epoxy . Journal of Engineering and Technology . Vol. 27 27 , No. 1515 . .
Khaled Rashad Al-Rawi, Rifqa Amer Salman, 2014 2014 . . A Study some of mechanical characteristics for composite, Epoxy-MgO . . Al - Nahrain University Journal of Science. Vol. 1717 , No.1 , PP.10 - . . 114
Wadad Hamdi Jasim, 2016 . . Preparation of composites of epoxy and eggs shells powder for use in coating of surfaces . Ibn al - Haytham Journal of Pure and Applied Sciences. Vol. 2929 , No. 1.
Wafa Abd Saud Al-Janabi , 1994. Mechanical characteristics of composites materials byباستخدام using fibers of the palms . M. Sc. Thesis, the University Technology.
Hisham Tawfiq, Abtahal Naimi , Qusay Kamal, 1999. Mechanical characteristics for strengthened epoxy material by metal wires.. Journal of Engineering and Technology. Vol. 81, No. 5.